G23 Infrared ray Photoelectric Switch Sensor

G23 photoelectric switch

Specification

 1 Basic form G: Infrared ray photoelectric switch 

2 Outward appearance code 18, 50, 76---- 
3 Working voltage 2.90-250VAC 3: 10-30VDC 4: 12-240VDC/24-240VAC 5: Special voltage 
4 Detection way A: Diffused reflection type(scattered reflection type) 
B: Feedbace reflection type mirror(mirror reflection type) 
C: Penetration type(correlation type) 
D: Marking detection type 
G: Optical fiber type 
5 Detection distance 05: 5cm 10: 10cm 30: 30cm 101: 10m 
6 Output form N: NPN transistor output P: PNP transistor output 
J: Relay contact output L: AC two-wire output 
S: With two outputs: NPN and PNP 
7 Output state A: Normally open(light entering ON) 
B: Normally close(light sheltering ON) 
C: Normally open+ normally close 
8 Subsidiary T1: Front delay T2: Rear delay Y: 
T: With aviation connector I: Special requirement 

 Structural category                                                                                                                          

Throuht-beam type

Through-beam bype photoelectric switch is designed that via the light beam between opposite-mounted transmitter and receiver, the object passing through these two devices will interrupt the light beam and start the receiver.

Diffuse type
Diffuse reflection type photoelectric switch integrates the transmitter and the reciver. Light reflected by the photoelectric switch is reflected back to the receiver by the detected object.

Retroreflective type
Retroreflective type photoelectric switch also integrates the transmitter and the receiver, Its difference from other models is that reflecotr is used to relfect light to the photoelectric switch. Though the object between the photoelectric switch and reflector can reflect the light, it is much less efficient than the reflector so as to cut down reflected light.

Convergence reflection type (condensation type)
The working principle of convergence reflection type photoswitch is similar to that of direct reflection type one, while its projector and light receiver focus on boject distance, only when the object presents to the focus can the photoswitch actuate.

Technical Parameter

Dimension