 |
| Input Voltage: | |
|---|---|
| Output Voltage: | |
YUMO Pure Sine Wave Inverter SGPE 1000w 12/24/48VDC New energy system (Color display and remote control is optional)
Producst Introduction
The high frequency pure sine wave inverter with E-display, original imported chip and MOSFET, dual ball temp
controlled fans, visible data to realize smart, reliable, low noise, high quality output. We design and produce pure
copper transformer, inductor by ourselves and meet all customer's demands. It can run all kinds of load stably
and the pure sine wave form is better than electricity. At the same time, input and output lines are designed to be
completely isolated to protect the system more safer.
ATTENTION
In connection cable should be used to install the appropriate cable, if the AC output cable is too long or the wire cross-sectional area is too small, will generate a large number of cable power loss, the load performance will be low power and low voltage.
If battery and inverter connection cable are not standardized, too long cable, too small cross-sectional, parts of contact too short, the inverter may not work but give an alarm, meanwhile cable must have waterproof, insulate strength to meet environment requires.
Environment for use
In order to get the best using results, please put the inverter on the flat surface, such as the ground, car floor, or other solid surface which can easily fixed the inverter’s power cord.
The working place should meet the following criteria:
Keep dry, should not let the inverter contact the water or other liquids, keep the inverter away from moisture or water.
Cool environment, keep the temperature between 0 Celsius degrees (no condensation) and 40 Celsius degrees.
Do not put the inverter next to heat vents or other heat devices. Try to keep the inverter not be shined directly by the sunshine.
Ventilation. No objects block around, and keep free flow of the air. Do not put anything on the inverter when it was working.
YUMO Pure Sine Wave Inverter SGPE 1000w 12/24/48VDC New energy system (Color display and remote control is optional)
Producst Introduction
The high frequency pure sine wave inverter with E-display, original imported chip and MOSFET, dual ball temp
controlled fans, visible data to realize smart, reliable, low noise, high quality output. We design and produce pure
copper transformer, inductor by ourselves and meet all customer's demands. It can run all kinds of load stably
and the pure sine wave form is better than electricity. At the same time, input and output lines are designed to be
completely isolated to protect the system more safer.
ATTENTION
In connection cable should be used to install the appropriate cable, if the AC output cable is too long or the wire cross-sectional area is too small, will generate a large number of cable power loss, the load performance will be low power and low voltage.
If battery and inverter connection cable are not standardized, too long cable, too small cross-sectional, parts of contact too short, the inverter may not work but give an alarm, meanwhile cable must have waterproof, insulate strength to meet environment requires.
Environment for use
In order to get the best using results, please put the inverter on the flat surface, such as the ground, car floor, or other solid surface which can easily fixed the inverter’s power cord.
The working place should meet the following criteria:
Keep dry, should not let the inverter contact the water or other liquids, keep the inverter away from moisture or water.
Cool environment, keep the temperature between 0 Celsius degrees (no condensation) and 40 Celsius degrees.
Do not put the inverter next to heat vents or other heat devices. Try to keep the inverter not be shined directly by the sunshine.
Ventilation. No objects block around, and keep free flow of the air. Do not put anything on the inverter when it was working.
