the Principle & Characteristics of Rotary Encoder

Publish Time: 2016-06-05 Origin: Site

Incremental Encoders Model

This model can output pulse according to the rotary displacement of the shaft.Calculate the number of output pulse and detect rotation amount by other counter
In order to know the rotation amount of the shaft, first reset the count value of counter based on the reference position,and then add up the pulse acount which is emitted by the position by counter.
So it can select reference position randomly and detect rotation amount unlimitedly.The greatest feature is that it can add circuits,produce 2 or 4 times pulse amount of a periodic signal,improve the resolution of circuit.(Note)
In addition,it can take signal Z, which is produced when rotated a cycle , as the origin of a rotation.
Note:When high resolution is needed,generally adopt 4 frequence doubling circuit.(If carry out differential coefficient to the rising,falling waveform of phase A and B,4 times output is available and the resolution is 4 times.)

		Structure Rotate plate with optical pattern at the same time when rotate the shaft,the light will continue the states of permeance and shutoff corresponding to two slits.This light will change into current by the optical components correspnding to each slit,and output as two rectangular wave after waveform shaping. Another two slit should be collocated at the position that has a phase difference of 1/4 pitch with rectangular wave output.
		◆ Output Waveform
		Single-Rotation Absolute Model
		The data of single-rotation absolute model has the same features as that of universal absolute model. The data of rotation amount can output as absolute data,and choose the type of battery, whether it needs supporting power when the power is cutted,according to the method of detecting rotating data. Adopt absolute encoder,apply to the occasion that absolutize the detection of encoder's position under any rotary state.
		◆ Output Waveform
		Absolute Encoder Model
		This model takes rotor angle as absolute address through the code 2ⁿparallel output.Therefore,if hold the sendout of output code bit,the sendout will increase if resolution is high,read out output code directly,detect rotating position. Once the encoder is installed to the machine,we can make sure of the origin of the shaft,generally take zero bit as the oringin,output the angle of rotation with digit.In addition, it won't happen the situation of data decadance which is caused by interference and so on,and it doesn't need to reset the origin when start. Besides,when it can't read out the sign because of high-speed rotating,if reduce the speed,it will be able to read out correct data.In addition,the power is cutted off because of blackout,it is able to read out correct data after turning the power.

the Principle & Characteristics of Rotary Encoder

Related Articles