Single-turn Absolute Encoder, 0-10V Analog Voltage Output, Body Size 38mm, 50mm, 58mm, Shaft Diameter Selectable Solid Shaft Encoder

Analog use instructions

The encoder uses the wire shorting method to set the starting position of the current output.

Example of 0-10V setting method

1. Connect the red wire of the encoder to the positive pole of the power supply and the black wire to the negative pole of the power supply.

2. Rotate the encoder to the position where the 0V voltage value needs to be set;

3, the orange wire is connected to the positive terminal of the power supply for a short period of time greater than 1 second and then loosened, suspended or grounded.

4、Rotate the encoder shaft to the position where the 10V voltage value needs to be set;

5, the yellow wire and power supply positive short connection, time greater than 1 second after the release, suspension or ground.

Up to this point the voltage output setting is complete, rotate the encoder between these two positions, the encoder output current varies continuously between 0-10V.

Note: It is not possible to set 0V and 10V in the same position.

If you have any questions, please contact us.

Specification parameter

CONNECTION TABLE